Crash
Articles
Recent activity by Crash
-
My Comet isn't turning on
Double check all cords are securely fastened to their ports, and try a different outlet. If it's still not working, please let us know your current address at support@toybox.com and we'll send you ...
- Updated
- 2 followers
- 0 comments
- 1 vote
-
My prints aren't sticking on my Comet print bed
If your prints aren't sticking to the bed, and the filament is balling up, try calibrating the printer down using these instructions here. If you need any help calibrating, please let us know at su...
- Updated
- 3 followers
- 0 comments
- -2 votes
-
My Comet nozzle is digging into the print bed
If the nozzle is too low, try calibrating the printer up using these instructions here. If you need any help calibrating, please let us know at support@toybox.com!
- Updated
- 2 followers
- 0 comments
- -1 votes
-
Putting tape on your Comet print bed
The Comet print bed is designed not to use painters tape. If you're having trouble getting your prints to stick, try calibrating down after removing the painters tape. The tape can cause the prompt...
- Updated
- 2 followers
- 0 comments
- -1 votes
-
WiFi Password says "incorrect" for my Comet
If possible, first move your Comet closer to the WiFi source and double check the WiFi is a 2.4G network (it won't work with 5G). Creating a WPA2 on your router network should help. To set up WPA...
- Updated
- 2 followers
- 0 comments
- 0 votes
-
The screen is all white, nothing is showing up
If the screen is all white and nothing is showing up, try unplugging the printer and plugging it back in a couple times until the screen changes! If it's still not working, please reach out to us ...
- Updated
- 2 followers
- 0 comments
- 0 votes
-
The screen says "bed mapping error"
This is likely the result of the extruder cable cord not being fully plugged into the extruder. Unplug and plug the cord back in, securing it firmly into the port. The end of the cord should dip sl...
- Updated
- 2 followers
- 0 comments
- -1 votes
-
The screen says "heater failed" or "extruder cable not plugged in"
This is likely the result of the extruder cable cord not being fully plugged into the extruder. Unplug and plug the cord back in, securing it firmly into the port. The end of the cord should dip sl...
- Updated
- 2 followers
- 0 comments
- 0 votes
-
How to Calibrate your Comet
Please click click here for instructions on how to calibrate your Comet. The nozzle should be close enough that a piece of paper should be able to graze the nozzle and slide underneath but not rip....
- Updated
- 4 followers
- 0 comments
- -6 votes
-
Creator Space Guide
At Toybox, our mission is to make it super easy for kids to design and print anything they can imagine. We're excited to show off our easy-to-use Build experience, which lets anyone create cool des...
- Updated
- 7 followers
- 0 comments
- -3 votes