Crash
Activity overview
Latest activity by Crash
-
Crash created an article,
My x axis on my Comet is squeaking
A couple drops at the ends of the top slots like in the photos should help. Put the tip about halfway inside the x axis so the drops will fall onto the belt/pulley. You can use a lubricant like o...
- Crash
- Updated
- 3 followers
- 1 comment
- -1 votes
-
Crash created an article,
Food won't catch in Comet nozzle/something is stuck inside the nozzle
First double check to make sure all the cords are securely fastened to their ports, specifically the cable connecting the extruder to the Comet base. Sometimes if the cords aren't all the way press...
- Crash
- Updated
- 1 follower
- 0 comments
- 0 votes
-
Crash created an article,
My Comet isn't turning on
Double check all cords are securely fastened to their ports, and try a different outlet. If it's still not working, please let us know your current address at support@toybox.com and we'll send you ...
- Crash
- Updated
- 1 follower
- 0 comments
- 1 vote
-
Crash created an article,
My prints aren't sticking on my Comet print bed
If your prints aren't sticking to the bed, and the filament is balling up, try calibrating the printer down using these instructions here. If you need any help calibrating, please let us know at su...
- Crash
- Updated
- 1 follower
- 0 comments
- -1 votes
-
Crash created an article,
My Comet nozzle is digging into the print bed
If the nozzle is too low, try calibrating the printer up using these instructions here. If you need any help calibrating, please let us know at support@toybox.com!
- Crash
- Updated
- 1 follower
- 0 comments
- 0 votes
-
Crash created an article,
Putting tape on your Comet print bed
The Comet print bed is designed not to use painters tape. If you're having trouble getting your prints to stick, try calibrating down after removing the painters tape. The tape can cause the prompt...
- Crash
- Updated
- 1 follower
- 0 comments
- -1 votes
-
Crash created an article,
WiFi Password says "incorrect" for my Comet
If possible, first move your Comet closer to the WiFi source and double check the WiFi is a 2.4G network (it won't work with 5G). Creating a WPA2 on your router network should help. To set up WPA...
- Crash
- Updated
- 1 follower
- 0 comments
- 0 votes
-
Crash created an article,
The screen is all white, nothing is showing up
If the screen is all white and nothing is showing up, try unplugging the printer and plugging it back in a couple times until the screen changes! If it's still not working, please reach out to us ...
- Crash
- Updated
- 1 follower
- 0 comments
- 0 votes
-
Crash created an article,
The screen says "bed mapping error"
This is likely the result of the extruder cable cord not being fully plugged into the extruder. Unplug and plug the cord back in, securing it firmly into the port. The end of the cord should dip sl...
- Crash
- Updated
- 1 follower
- 0 comments
- 0 votes
-
Crash created an article,
The screen says "heater failed" or "extruder cable not plugged in"
This is likely the result of the extruder cable cord not being fully plugged into the extruder. Unplug and plug the cord back in, securing it firmly into the port. The end of the cord should dip sl...
- Crash
- Updated
- 1 follower
- 0 comments
- 0 votes